| 1. | Study on valence electron theory of phase relationship in a m transformation
奥氏体向马氏体转变时位向关系的价电子理论研究 |
| 2. | Under these conditions , energy will arrive at point p with the same phase relationship that existed at the array
在这个条件下，阵列的能量以相同的相位到达p点。 |
| 3. | Finally , the phase relationships between the movements of boxfish fins are estimated to describe coordination between the propulsors
首先提出一系列模型建立所需的简化假设,并对其合理性进行讨论。 |
| 4. | The employment of time delay as a means of achieving the desired phase relationships between elements allows greater flexibility in frequency utilization than other methods
使用时滞作为获得所需要的单元间相位关系的手段具有比其他方法更大的频率使用弹性。 |
| 5. | Sync check relay a sync check relay is an electrical device that monitors the phase relationship between two voltage sources and provides a signal when the voltage sources are within specific preset parameters
同步检查继电器同步检查继电器是监测两个电压源之间的相位关系的电气设备，如果电压源间的关系在预定的参数范围内，它就会发出相应信号。 |
| 6. | Synchronizer a synchronizer is an electronic device that monitors the phase relationship between two voltage sources and provides a connection signal to an engine governor , to force the generator set to synchronize to the system bus
同步器同步器是用来监测两个电压源之间的相位关系的电子设备，它向发动机调速器发出信号，以促使发电机组与系统母排能够同步。 |
| 7. | Calibration will be made by applying appropriate sinusoidal voltage and current signals with known phase relationship to the meter under test . the ranges of test voltages and currents are 25 v to 250 v and 50 ma to 100 a respectively
按已知的相位关系，将适当的正弦电压及电流讯号加于接受测试的功率因数表，以进行校正。测试电压及电流量程分别为25v至250v及50ma至100a 。 |
| 8. | To receive energy transmitted in a steered beam by any of the three scanning methods , the applied frequency , time , or phase relationships are maintained at each element , which has the effect of making the radar sensitive to energy from the direction of transmission
仍然以每个单元接收通过三种扫描方法? ?频率，时间，相位关系控制波束发射的能量，这使雷达对发射方向的能量敏感。 |
| 9. | But the influence trend of the maximum rolling angle and the rolling period was not so simple , it was because the influence of which embodied in the phase relationship of mass flow and the pressure drop across the tube . the d - partition method was developed to separate the test tube into four regions and the drift flow model was imported into the two phase region , based on which the solution of the response of the pressure drop of tested tube to the inlet mass flow perturbation can be obtained
在不摇摆和摇摆工况下，采用d分区法对实验段进行分区，在两相区采用漂移流模型对实验段的压降对入口流速扰动的响应进行了求解，给出了各区压降响应的表达式，进而得到了在不摇摆和摇摆工况下，压降与入口流速扰动之间的传递函数。 |
